Papalocal
Loading…
Papalocal · Places
River

Henrys Fork

Madison County · Idaho

Henrys Fork is a river in Madison and Fremont counties in Idaho. It is 204 km (127 mi) long. It begins at Henrys Lake. It flows into the Snake River.

Length
204 km (127 mi)
Begins at
Henrys Lake
Flows into
Snake River
Located in
Madison County
Tributaries
Teton River
Basin
Henrys Fork drainage basin
All 10 facts, and where they come from

Facts

10 facts · 0 confirmed by two sources · 0 cited · 10 from one source

What it is
river One source
Located in
Madison County One source
Fremont County One source
Country
United States One source
Length
204 km (127 mi) One source
Begins at
Henrys Lake One source
Flows into
Snake River One source
Tributaries
Teton River One source
Fall River One source
Basin
Henrys Fork drainage basin One source

Where this comes from

Papalocal keeps its own record. It started from these sources; what each one said is kept here as it was copied, so a change on their side never changes this page by itself. Tap one to read its version.

What Wikidata says · copied November 16, 2026 · revision 2570357174
Described as
river in Madison and Fremont counties in Idaho, United States
Other names
Henry's Fork, Henry Fork, Henry's Fork of the Snake Rive, Henrys Fork of Snake River, Henrys Fork of the Snake River, North Fork Snake River, Upper Henrys Fork River
What it is
river
Located in
Madison County; Fremont County
Country
United States
Length
204 km (127 mi)
Begins at
Henrys Lake
Flows into
Snake River
Tributaries
Teton River; Fall River
Basin
Henrys Fork drainage basin
Wikipedias with a page
8

Wikidata item Q4497256 (wikidata.org/wiki/Q4497256), public domain (CC0). Copied 2026-11-16.

What Wikipedia says · copied November 16, 2026 · revision 1367742007

Henrys Fork is a tributary river of the Snake River, approximately 127 miles (204 km) long, in southeastern Idaho in the United States. It is also referred to as the North Fork of the Snake River. Its drainage basin is 3,212 square miles (8,320 km2), including its main tributary, the Teton River. Its mean annual discharge, as measured at river mile 9.2 (Henrys Fork near Rexburg) by the United States Geological Survey (USGS), is 2,096 cubic feet per second (59.4 m3/s), with a maximum daily recorded flow of 79,000 cubic feet per second (2,240 m3/s), and a minimum of 183 cubic feet per second (5.18 m3/s). It is normally transcribed without an apostrophe.
The river is named for Andrew Henry, who first entered the Snake River plateau in 1810. Employed by the Missouri Fur Company, he built Fort Henry on the upper Snake River, near modern St. Anthony, but abandoned this first American fur post west of the continental divide the following spring.

From the Wikipedia article “Henrys Fork (Snake River tributary)” (en.wikipedia.org/wiki/Henrys_Fork_(Snake_River_tributary)), by its contributors, under CC BY-SA 4.0 (creativecommons.org/licenses/by-sa/4.0/). Copied 2026-11-16; not changed.

Confirmed Two sources agree. Cited One source, and it names where it got it. One source One source, without a reference of its own. Sources disagree The sources disagree. We show the best-supported value and keep theirs below.

Picture: Wikimedia Commons: Us-id-henrys-fork.jpg · See Commons file page

More nature nearby